All Universal IV CM comes from the factory pre-calibrated and requires only one point validation. Field configuration can be done from anywhere along the two-wire loop with our HRTWin PC Software.

Category:

Description

Universal IV Cut Monitor

All Universal IV CM comes from the factory pre-calibrated and requires only one point validation.
Field configuration can be done from anywhere along the two-wire loop with our HRTWin PC Software. You can also configure via local display / keypad without the need for laptop or handheld communicators.
 
Durability:
 
Our Perm-A-Seal sensing element does not need epoxy coatings that wear out and need expensive servicing. There are no gaskets that need servicing. The sensing element is robust in well fluids that include large amounts of sand.
 
End Routine Maintenance:
 
The Universal IV Cut Monitor is built upon the Drexelbrook expertise in RF Admittance. This allows the electronics to ignore paraffin and other coatings that buildup on the probe. No need to take apart spool pieces and tie-off large pipelines. The Universal IV CM can be configured for NPT or flanged mountings and can be installed in common pipe diameters.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.